National Cheng Kung University

About: National Cheng Kung University is a education organization based out in Tainan City, Taiwan. It is known for research contribution in the topics: Population & Thin film. The organization has 49723 authors who have published 69799 publications receiving 1437420 citations. The organization is also known as: NCKU.

Free anterolateral thigh flap for reconstruction of head and neck defects following cancer ablation.

Abstract: Thirty-seven consecutive free anterolateral thigh flaps in 36 patients were transferred for reconstruction of head and neck defects following cancer ablation between January of 1997 and June of 1998. The success rate was 97 percent (36 of 37), with one flap lost due to a twisted perforator. The anatomic variations and length of the vascular pedicle were investigated to obtain better knowledge of anatomy and to avoid several surgical pitfalls when it is used for head and neck reconstruction. The cutaneous perforators were always found and presented as musculocutaneous or septocutaneous perforators in this series of 37 anterolateral thigh flaps. They were classified into four types according to the perforator derivation and the direction in which it traversed the vastus lateralis muscle. In type I, vertical musculocutaneous perforators from the descending branch of the lateral circumflex femoral artery were found in 56.8 percent of cases (21 of 37), and they were 4.83 +/- 2.04 cm in length. In type II, horizontal musculocutaneous perforators from the transverse branch of the lateral circumflex femoral artery were found in 27.0 percent of cases (10 of 37), and they were 6.77 +/- 3.48 cm in length. In type III, vertical septocutaneous perforators from the descending branch of the lateral circumflex femoral artery were found in 10.8 percent of cases (4 of 37), and they were 3.60 +/- 1.47 cm in length. In type IV, horizontal septocutaneous perforators from the transverse branch of the lateral circumflex femoral artery were found in 5.4 percent of cases (2 of 37). They were 7.75 +/- 1.06 cm in length. The average length of vascular pedicle was 12.01 +/- 1.50 cm, and the arterial diameter was around 2.0 to 2.5 mm; two accompanying veins varied from 1.8 to 3.0 mm and were suitable for anastomosis with the neck vessels. Reconstruction of one-layer defect, external skin or intraoral lining, was carried out in 18 cases, through-and-through defect in 17 cases, and composite mandibular defect in two cases. With increasing knowledge of anatomy and refinements of surgical technique, the anterolateral thigh flap can be harvested safely to reconstruct complicated defects of head and neck following cancer ablation with only minimal donor-site morbidity.

An integrated dielectrophoretic chip for continuous bioparticle filtering, focusing, sorting, trapping, and detecting

Abstract: Multi-target pathogen detection using heterogeneous medical samples require continuous filtering, sorting, and trapping of debris, bioparticles, and immunocolloids within a diagnostic chip. We present an integrated AC dielectrophoretic (DEP) microfluidic platform based on planar electrodes that form three-dimensional (3D) DEP gates. This platform can continuously perform these tasks with a throughput of 3 muLmin. Mixtures of latex particles, Escherichia coli Nissle, Lactobacillus, and Candida albicans are sorted and concentrated by these 3D DEP gates. Surface enhanced Raman scattering is used as an on-chip detection method on the concentrated bacteria. A processing rate of 500 bacteria was estimated when 100 mul of a heterogeneous colony of 10(7) colony forming units ml was processed in a single pass within 30 min.

Functionalizing Carbon Nanotubes by Plasma Modification for the Preparation of Covalent-Integrated Epoxy Composites

Abstract: A novel method for preparing a fully integrated nanotube composite material through the use of functionalized multi-walled carbon nanotubes (MWNTs) is presented in this study. The functionalization of MWNTs was performed via plasma treatment; subsequently, maleic anhydride (MA) was grafted onto the MWNTs (CNTs-MA). Nanotube-reinforced epoxy polymer composites were prepared by first mixing the CNTs-MA and a diamine curing agent, followed by a further reaction with the epoxy matrix. In this hybrid nanocomposite system, the CNTs-MA were covalently integrated into the epoxy matrix and became part of the cross-linked structure rather than just a separate component. Fourier transform infrared (FT-IR) and high resolution X-ray photoelectron (XPS) spectroscopes were used to characterize the functional groups on the surface of the MWNTs after the plasma modification. In addition, observations of scanning electronic microscopy (SEM) and transmission electron microscopy (TEM) images showed that the functionalized na...