University of Malaya

About: University of Malaya is a education organization based out in Kuala Lumpur, Malaysia. It is known for research contribution in the topics: Population & Fiber laser. The organization has 25087 authors who have published 51491 publications receiving 1036791 citations. The organization is also known as: UM & Universiti Malaya.

Biodiesel from palmoil—an analysis of its properties and potential

Abstract: If the agricultural products market is limited and much of agricultural land is not utilized as is the case in many countries in the world at present, then agriculture should be directed to the production of new alternative products. The land can be used to produce non-food products including biodiesels for the domestic energy market to diminish imports. Much research has been done on biodiesels over the last 20 yr after the oil crisis in 1973. At present, concern about environmental regulations has been the major reason to look for alternative fuel. A significant level in terms of physico-chemical properties of biodiesel has been obtained but there is a lack of full or partial replacement of fossil fuel that needs to be discussed. This paper presents the experimental results carried out to evaluate the effect of anticorrosion additive in biodiesel (from palm oil) on diesel engines, performance, emissions and wear characteristics. This biodiesel is defined as the methyl ester of palm oil also known as palm oil diesel. The results of this investigation will be used to find compatible lubricant for biodiesel engine.

Constraints on the spin-parity and anomalous HVV couplings of the Higgs boson in proton collisions at 7 and 8 TeV

Abstract: The study of the spin-parity and tensor structure of the interactions of the recently discovered Higgs boson is performed using the H to ZZ, Z gamma*, gamma* gamma* to 4 l, H to WW to l nu l nu, and H to gamma gamma decay modes. The full dataset recorded by the CMS experiment during the LHC Run 1 is used, corresponding to an integrated luminosity of up to 5.1 inverse femtobarns at a center-of-mass energy of 7 TeV and up to 19.7 inverse femtobarns at 8 TeV. A wide range of spin-two models is excluded at a 99% confidence level or higher, or at a 99.87% confidence level for the minimal gravity-like couplings, regardless of whether assumptions are made on the production mechanism. Any mixed-parity spin-one state is excluded in the ZZ and WW modes at a greater than 99.999% confidence level. Under the hypothesis that the resonance is a spin-zero boson, the tensor structure of the interactions of the Higgs boson with two vector bosons ZZ, Z gamma, gamma gamma, and WW is investigated and limits on eleven anomalous contributions are set. Tighter constraints on anomalous HVV interactions are obtained by combining the HZZ and HWW measurements. All observations are consistent with the expectations for the standard model Higgs boson with the quantum numbers J[PC]=0[++].

A review on electrical motors energy use and energy savings

Abstract: The industrial sector is the largest users of energy around the world. Industrial motor uses a major fraction of total industrial energy uses. This paper describes a comprehensive literature review about electric motor energy analysis. This paper compiles latest literatures in terms of thesis (MS and PhD), journal articles, conference proceedings, web materials, reports, books, handbooks on electrical motor energy use, losses, efficiency, energy savings strategies. Different types of losses that occur in a motor have been identified and ways to overcome these losses explained. An energy audit that helps to identify motor energy wastages have been discussed extensively. As motors are the major energy users, different energy savings strategies such as use of high-efficient motor, variable speed drive (VSD), and capacitor bank to improve the power factor to reduce their energy uses have reviewed. Different policy measures (i.e. regulatory, voluntary and incentives based) to save motor energy use have been reviewed and presented in this paper. In this review, computer tools that can be used to analyze electric motors energy used has been discussed. Cost parameters to carry out economic analysis have been shown as well. Moreover, payback period for different energy savings strategies have been identified.

A systematic development process for patient decision aids

Abstract: The original version of the International Patient Decision Aid Standards (IPDAS) recommended that patient decision aids (PtDAs) should be carefully developed, user-tested and open to scrutiny, with a well-documented and systematically applied development process. We carried out a review to check the relevance and scope of this quality dimension and, if necessary, to update it. Our review drew on three sources: a) published papers describing PtDAs evaluated in randomised controlled trials and included in the most recent Cochrane Collaboration review; b) linked papers cited in the trial reports that described how the PtDAs had been developed; and c) papers and web reports outlining the development process used by organisations experienced in developing multiple PtDAs. We then developed an extended model of the development process indicating the various steps on which documentation is required, as well as a checklist to assess the frequency with which each of the elements was publicly reported. Key features common to all patient decision aid (PtDA) development processes include: scoping and design; development of a prototype; ‘alpha’ testing with patients and clinicians in an iterative process; ‘beta’ testing in ‘real life’ conditions (field tests); and production of a final version for use and/or further evaluation. Only about half of the published reports on the development of PtDAs that we reviewed appear to have been field tested with patients, and even fewer had been reviewed or tested by clinicians not involved in the development process. Very few described a distribution strategy, and surprisingly few (17%) described a method for reviewing and synthesizing the clinical evidence. We describe a model development process that includes all the original elements of the original IPDAS criterion, expanded to include consideration of format and distribution plans as well as prototype development. The case for including each of the elements outlined in our model development process is pragmatic rather than evidence-based. Optimal methods for ensuring that each stage of the process is carried out effectively require further development and testing.