Tohoku University

About: Tohoku University is a education organization based out in Sendai, Japan. It is known for research contribution in the topics: Magnetization & Alloy. The organization has 72116 authors who have published 170791 publications receiving 3941714 citations. The organization is also known as: Tōhoku daigaku.

Constraints on neutrino oscillations using 1258 days of Super-Kamiokande solar neutrino data.

Abstract: We report the result of a search for neutrino oscillations using precise measurements of the recoil electron energy spectrum and zenith angle variations of the solar neutrino flux from 1258 days of neutrino-electron scattering data in Super-Kamiokande The absence of significant zenith angle variation and spectrum distortion places strong constraints on neutrino mixing and mass difference in a flux-independent way Using the Super-Kamiokande flux measurement in addition, two allowed regions at large mixing are found

Trypsin Action on the Growth of Sendai Virus in Tissue Culture Cells III. Structural Difference of Sendai Viruses Grown in Eggs and Tissue Culture Cells

Abstract: Polypeptides of egg-borne Sendai virus (egg Sendai), which is biologically active on the basis of criteria of the infectivity for L cells and of hemolytic and cell fusion activities, were compared by polyacrylamide gel electrophoresis with those of L cell-borne (L Sendai) and HeLa cell-borne Sendai (HeLa Sendai) viruses, which are judged biologically inactive by the above criteria. Densitometer profiles on the stained gels of egg Sendai resolved six polypeptides (virion protein [VP] 1 to VP6), in which VP2 and VP4 were identified as glycoproteins by PAS stain. Comparative electropherograms of both L Sendai and HeLa Sendai revealed that there were significantly larger amounts in the VP2 region of these viruses but VP4 was present only in greatly reduced amounts as compared to egg Sendai. It was also found that VP2 of L Sendai and HeLa Sendai consisted of two components, VP2a and VP2b, but the one of egg Sendai consisted of only VP2a. A mild trypsin treatment which converts both L Sendai and HeLa Sendai to a biologically active form selectively removed VP2b from these viruses and increased concomitantly the amounts of materials in the VP4 region. The same treatment of egg Sendai affected neither its biological activities nor its electropherogram. Consequently, gross polypeptide profiles on the stained gels of L Sendai and HeLa Sendai after trypsin treatment became favorably comparable to that of egg Sendai. Electrophoresis of labeled L Sendai and HeLa Sendai with a (3)H-amino acids mixture and (14)C-glucosamine resolved at least three glycoproteins, GP1, GP2, and GP3, each corresponding to VP2a, VP2b, and VP4, respectively. The trypsin treatment of these viruses removed almost all the radioactivity of GP2 and simultaneously increased the radioactive counts of GP3 and raised small amounts of rapidly moving heterogeneous glycoprotein, GP4. A possible relationship between the biological modification and the above characteristic polypeptide patterns of Sendai virus was discussed.

Emergency response to the nuclear accident at the Fukushima Daiichi Nuclear Power Plants using mobile rescue robots

Abstract: On March 11, 2011, a massive earthquake (magnitude 9.0) and accompanying tsunami hit the Tohoku region of eastern Japan. Since then, the Fukushima Daiichi Nuclear Power Plants have been facing a crisis due to the loss of all power that resulted from the meltdown accidents. Three buildings housing nuclear reactors were seriously damaged from hydrogen explosions, and, in one building, the nuclear reactions became out of control. It was too dangerous for humans to enter the buildings to inspect the damage because radioactive materials were also being released. In response to this crisis, it was decided that mobile rescue robots would be used to carry out surveillance missions. The mobile rescue robots needed could not be delivered to the Tokyo Electric Power Company (TEPCO) until various technical issues were resolved. Those issues involved hardware reliability, communication functions, and the ability of the robots' electronic components to withstand radiation. Additional sensors and functionality that would enable the robots to respond effectively to the crisis were also needed. Available robots were therefore retrofitted for the disaster reponse missions. First, the radiation tolerance of the electronic componenets was checked by means of gamma ray irradiation tests, which were conducted using the facilities of the Japan Atomic Energy Agency (JAEA). The commercial electronic devices used in the original robot systems operated long enough (more than 100 h at a 10% safety margin) in the assumed environment (100 mGy/h). Next, the usability of wireless communication in the target environment was assessed. Such tests were not possible in the target environment itself, so they were performed at the Hamaoka Daiichi Nuclear Power Plants, which are similar to the target environment. As previously predicted, the test results indicated that robust wireless communication would not be possible in the reactor buildings. It was therefore determined that a wired communication device would need to be installed. After TEPCO's official urgent mission proposal was received, the team mounted additional devices to facilitate the installation of a water gauge in the basement of the reactor buildings to determine flooding levels. While these preparations were taking place, prospective robot operators from TEPCO trained in a laboratory environment. Finally, one of the robots was delivered to the Fukushima Daiichi Nuclear Power Plants on June 20, 2011, where it performed a number of important missions inside the buildings. In this paper, the requirements for the exploration mission in the Fukushima Daiichi Nuclear Power Plants are presented, the implementation is discussed, and the results of the mission are reported. © 2013 Wiley Periodicals, Inc. (Webpage: http://www.astro.mech.tohoku.ac.jp/)

Transformation of Yttria‐Doped Tetragonal ZrO2 Polycrystals by Annealing in Water

Abstract: Phase changes and the microstructure resulting from low-temperature annealing of yttria-doped tetragonal ZrO2 polycrystals in water were investigated at 65° to 120°C. Tetragonal ZrO2 on the surface of the sintered body transformed to the monoclinic phase, accompanied by microcracking. The transformation rate in water, which was much greater than that in air, was first order with respect to surface concentration of tetragonal ZrO2. Nonaqueous solvents with a molecular structure containing a lone-pair electron orbital opposite a proton donor site also greatly enhanced the transformation.