scispace - formally typeset
Journal ArticleDOI

Utilization of sewage sludge in EU application of old and new methods—A review

Reads0
Chats0
TLDR
In this article, the authors review past and future trends in sludge handling, focusing mainly at thermal processes (e.g. pyrolysis, wet oxidation, gasification) and the utilization of sewage sludge in cement manufacture as a co-fuel.
Abstract
The European Union has made progress in dealing with municipal wastewater in individual countries and as a corporate entity. However, it intends to make still further and substantial progress over the next 15 years. Currently, the most widely available options in the EU are the agriculture utilization, the waste disposal sites, the land reclamation and restoration, the incineration and other novel uses. The selection of an option on a local basis reflects local or national, cultural, historical, geographical, legal, political and economic circumstances. The degree of flexibility varies from country to country. In any case sludge treatment and disposal should always be considered as an integral part of treatment of wastewater. There is a wide range of other uses for sludge, which exploit its energy or chemical content, namely the thermal processes. The present paper sought to review past and future trends in sludge handling, focusing mainly at thermal processes (e.g. pyrolysis, wet oxidation, gasification) and the utilization of sewage sludge in cement manufacture as a co-fuel.

read more

Citations
More filters
Journal ArticleDOI

Stabilization of liming sludge in brick production: A way to reduce pollution in tannery

TL;DR: In this article, the authors used hair burning liming operation to remove the hair/wool, epidermis, fat, grease, and non-structural proteins, which is a hazardous waste that has a serious impact on the environment.
Journal ArticleDOI

Optimized sampling strategy for measurement of biomass properties during full-scale composting:

TL;DR: This study focuses on the development of a strategy for sampling under full-scale conditions for minimum measurement uncertainty based on selected material properties by considering multiple parameters, such as number of pile turnings before sampling, number of samples collected, sample mass, sample homogenization, particle size reduction and number of replicate measurements.
Journal ArticleDOI

Stabilization of liming sludge in brick production: A way to reduce pollution in tannery

TL;DR: In this paper , a building bricks were made under field conditions, where liming sludge (w/w) were incorporated by 2, 4, 6, 8, 10, and 12%, and fired in a kiln at 1000 °C.
Journal ArticleDOI

Biochar produced from the co-pyrolysis of sewage sludge and waste tires for cadmium and tetracycline adsorption from water.

TL;DR: In this article, sludge-tire composite biochar (STB) was successfully prepared through co-pyrolysis at 300, 500 and 700 °C, respectively.

ASSESSMENT OF TOXIC ELEMENTS Cu, Cr, Ni, Pb, Cd, Hg, Zn, As AND HEXAVALENT CHROMIUM IN SEWAGE SLUDGE FROM MUNICIPAL WASTEWATER TREATMENT PLANTS BY COMBINED SPECTROSCOPIC TECHNIQUES

TL;DR: In this paper, the concentration of toxic elements in wastewater sludge from three municipal wastewater treatment plants (WWTPs) in Northern Greece (Kavala, Drama and Palio) was determined using spectroscopic techniques.
References
More filters
Journal ArticleDOI

Sequential extraction procedure for the speciation of particulate trace metals

TL;DR: In this paper, an analytical procedure involving sequential chemicai extractions was developed for the partitioning of particulate trace metals (Cd, Co, Cu, Ni, Pb, Zn, Fe, and Mn) into five fractions: exchangeable, bound to carbonates, binding to Fe-Mn oxides and bound to organic matter.
Book

Wastewater Engineering Treatment Disposal Reuse

TL;DR: Wastewater Engineering: An Overview of Wastewater Engineering, Methods and Implementation Considerations as mentioned in this paper is a good starting point for a discussion of the issues of wastewater engineering. But, it is not a complete survey of the entire literature.
Journal ArticleDOI

Sewage sludge combustion

TL;DR: In this article, a review of the current and future issues related to the combustion of sewage sludge is presented, and a number of technologies for thermal processing of sludge are discussed in three groups, i.e., mono-combustion, cocombustions and alternative processes.
Journal ArticleDOI

Trace metal analysis on polluted sediments

TL;DR: In this article, the authors proposed a standardization with respect to grain size effects, commonly achieved by analyzing the sieve fraction <63μm, which is used to pin point major sources of metal pollution and to estimate the toxicity potential of dredged materials.
Related Papers (5)