scispace - formally typeset
Journal ArticleDOI

Utilization of sewage sludge in EU application of old and new methods—A review

TLDR
In this article, the authors review past and future trends in sludge handling, focusing mainly at thermal processes (e.g. pyrolysis, wet oxidation, gasification) and the utilization of sewage sludge in cement manufacture as a co-fuel.
Abstract
The European Union has made progress in dealing with municipal wastewater in individual countries and as a corporate entity. However, it intends to make still further and substantial progress over the next 15 years. Currently, the most widely available options in the EU are the agriculture utilization, the waste disposal sites, the land reclamation and restoration, the incineration and other novel uses. The selection of an option on a local basis reflects local or national, cultural, historical, geographical, legal, political and economic circumstances. The degree of flexibility varies from country to country. In any case sludge treatment and disposal should always be considered as an integral part of treatment of wastewater. There is a wide range of other uses for sludge, which exploit its energy or chemical content, namely the thermal processes. The present paper sought to review past and future trends in sludge handling, focusing mainly at thermal processes (e.g. pyrolysis, wet oxidation, gasification) and the utilization of sewage sludge in cement manufacture as a co-fuel.

read more

Citations
More filters
Journal ArticleDOI

Techno-Economic Analysis of the Production of Liquid Biofuels from Sewage Sludge via Hydrothermal Liquefaction

TL;DR: In this article , the authors address the process and economic performance of the production of gasoline and diesel range fuels from urban sewage sludge, and propose an overall production route that involves direct conversion of the sewage to an intermediate oil phase via hydrothermal liquefaction at near-critical water conditions and further upgrading of the biocrude based on conventional refinery processes.
Book ChapterDOI

Influence of Plant Biomass Added to Sewage Sludge on the Product Energy Potential

TL;DR: In this paper, the authors evaluated the influence of plant biomass added to sewage sludge on the product energy potential in order to improve its physical properties, including the moisture of materials, the contents of volatile matter, combined carbon, heat of combustion and calorific value.
Journal ArticleDOI

Suitability of Wastewater Sludge for Utilization in the Leningrad Region (Russia)

TL;DR: In this paper, the properties and composition of wastewater sludge from two different municipal wastewater treatment plants are defined and discussed in the paper, and the effect of the properties on energy and nutrient recovery purposes are evaluated.
References
More filters
Journal ArticleDOI

Sequential extraction procedure for the speciation of particulate trace metals

TL;DR: In this paper, an analytical procedure involving sequential chemicai extractions was developed for the partitioning of particulate trace metals (Cd, Co, Cu, Ni, Pb, Zn, Fe, and Mn) into five fractions: exchangeable, bound to carbonates, binding to Fe-Mn oxides and bound to organic matter.
Book

Wastewater Engineering Treatment Disposal Reuse

TL;DR: Wastewater Engineering: An Overview of Wastewater Engineering, Methods and Implementation Considerations as mentioned in this paper is a good starting point for a discussion of the issues of wastewater engineering. But, it is not a complete survey of the entire literature.
Journal ArticleDOI

Sewage sludge combustion

TL;DR: In this article, a review of the current and future issues related to the combustion of sewage sludge is presented, and a number of technologies for thermal processing of sludge are discussed in three groups, i.e., mono-combustion, cocombustions and alternative processes.
Journal ArticleDOI

Trace metal analysis on polluted sediments

TL;DR: In this article, the authors proposed a standardization with respect to grain size effects, commonly achieved by analyzing the sieve fraction <63μm, which is used to pin point major sources of metal pollution and to estimate the toxicity potential of dredged materials.
Related Papers (5)