There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality.

Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

I and i

抗原变异可使得多种致病微生物易于逃避宿主免疫应答。表达在感染红细胞表面的恶性疟原虫红细胞表面蛋白1（PfPMP1）与感染红细胞、内皮细胞、树突状细胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作用。每个单倍体基因组var基因家族编码约60种成员，通过启动转录不同的var基因变异体为抗原变异提供了分子基础。

疟原虫var基因转换速率变化导致抗原变异[英]／Paul H, Robert P, Christodoulou Z, et al//Proc Natl Acad Sci U S A

Many materials systems are currently under consideration as potential replacements for SiO2 as the gate dielectric material for sub-0.1 μm complementary metal–oxide–semiconductor (CMOS) technology. A systematic consideration of the required properties of gate dielectrics indicates that the key guidelines for selecting an alternative gate dielectric are (a) permittivity, band gap, and band alignment to silicon, (b) thermodynamic stability, (c) film morphology, (d) interface quality, (e) compatibility with the current or expected materials to be used in processing for CMOS devices, (f) process compatibility, and (g) reliability. Many dielectrics appear favorable in some of these areas, but very few materials are promising with respect to all of these guidelines. A review of current work and literature in the area of alternate gate dielectrics is given. Based on reported results and fundamental considerations, the pseudobinary materials systems offer large flexibility and show the most promise toward success...

/pdf/high-k-gate-dielectrics-current-status-and-materials-zjvba0c4u8.pdf

High-κ gate dielectrics: Current status and materials properties considerations

The CMOS technology area has quickly grown, calling for a new text--and here it is, covering the analysis and design of CMOS integrated circuits that practicing engineers need to master to succeed. Filled with many examples and chapter-ending problems, the book not only describes the thought process behind each circuit topology, but also considers the rationale behind each modification. The analysis and design techniques focus on CMOS circuits but also apply to other IC technologies.
Table of contents

1 Introduction to Analog Design
2 Basic MOS Device Physics
3 Single-Stage Amplifiers
4 Differential Amplifiers
5 Passive and Active Current Mirrors
6 Frequency Response of Amplifiers
7 Noise
8 Feedback
9 Operational Amplifiers
10 Stability and Frequency Compensation
11 Bandgap References
12 Introduction to Switched-Capacitor Circuits
13 Nonlinearity and Mismatch
14 Oscillators
15 Phase-Locked Loops
16 Short-Channel Effects and Device Models
17 CMOS Processing Technology
18 Layout and Packaging

/pdf/design-of-analog-cmos-integrated-circuits-35wxhwa3a6.pdf

Design of Analog CMOS Integrated Circuits

Nanocrystals (NCs) discussed in this Review are tiny crystals of metals, semiconductors, and magnetic material consisting of hundreds to a few thousand atoms each. Their size ranges from 2-3 to about 20 nm. What is special about this size regime that placed NCs among the hottest research topics of the last decades? The quantum mechanical coupling * To whom correspondence should be addressed. E-mail: dvtalapin@uchicago.edu. † The University of Chicago. ‡ Argonne National Lab. Chem. Rev. 2010, 110, 389–458 389

/pdf/prospects-of-colloidal-nanocrystals-for-electronic-and-3dxpyhl3r7.pdf

Prospects of Colloidal Nanocrystals for Electronic and Optoelectronic Applications

We have demonstrated feasibility to form silicon-on-insulator (SOI) substrates using plasma immersion ion implantation (PIII) for both separation by implantation of oxygen and ion-cut. This high throughput technique can substantially lower the high cost of SOI substrates due to the simpler implanter design as well as ease of maintenance. For separation by plasma implantation of oxygen wafers, secondary ion mass spectrometry analysis and cross-sectional transmission electron micrographs show continuous buried oxide formation under a single-crystal silicon overlayer with sharp Si/SiO2 interfaces after oxygen plasma implantation and high-temperature (1300°C) annealing. Ion-cut SOI wafer fabrication technique is implemented for the first time using PIII. The hydrogen plasma can be optimized so that only one ion species is dominant in concentration and there are minimal effects by other residual ions on the ion-cut process. The physical mechanism of hydrogen induced silicon surface layer cleavage has been investigated. An ideal gas law model of the microcavity internal pressure combined with a two-dimensional finite element fracture mechanics model is used to approximate the fracture driving force which is sufficient to overcome the silicon fracture resistance.

Plasma immersion ion implantation for SOI synthesis: SIMOX and ion-cut

This paper proposes a new 8T nonvolatile SRAM (nvSRAM) cell employing ULP FinFETs and ferroelectric FinFETs to enable energy-efficient and low-latency store/recall operations. Different from other types of nvSRAM requiring additional circuitry or nonvolatile memories connected to a standard 6T SRAM cell to achieve nonvolatility, the proposed hybrid nvSRAM cell reduces the area penalty by embedding the nonvolatile ferroelectric FinFETs in a 6T SRAM cell without sacrificing the cell stability, read/write performance and power consumption.

/pdf/a-new-8t-hybrid-nonvolatile-sram-with-ferroelectric-fet-zcr3byb3r9.pdf

A New 8T Hybrid Nonvolatile SRAM with Ferroelectric FET

We report the feasibility and effectiveness of short voltage stress for oxide defect screen in this paper. Wafer-level in-process voltage stress rather than post-process burn-in may be necessary for defect screening, so that all the thin oxides can be accessed and higher voltage may be used to accelerate the burn-in. Oxide breakdown theory has been successfully used to model this defect control method. >

Efficient gate oxide defect screen for VLSI reliability

Atom movements of Cu in pure Cu and Cu(0.5 to 2 wt.% Sn) alloys have been investigated using drift velocity and radioactive tracer techniques. The void growth rate in pure Cu at the cathode end, as a result of electromigration driving force, linearly increases with the applied current density. A marked decrease in the Cu grain boundary diffusivity and electromigration drift velocity is attributed to Sn trapping of Cu atoms and/or binding defects at grain boundaries. The effect is more pronounced at lower temperatures. The activation energies for electromigration and diffusion of Cu in pure Cu grain boundaries were found to be in the range of 0.7 - 0.9 eV. Addition of about 0.5 to 2 wt.% Sn increased these energies to 1.1 - 1.3 eV, respectively which resulted in enhancement of electromigration resistance by several orders of magnitude over that in pure Cu at the field operation temperature.

Electromigration and Diffusion in Pure Cu And Cu(Sn) Alloys

A semi-quantitative model for the lateral channel electric field in LDD MOSFET's has been developed. This model is derived from a quasi-two-dimensional analysis under the assumption of a uniform doping profile. A field reduction factor, indicating the effectiveness of an LDD design in reducing the peak channel field, is used to compared LDD structures with, without, and with partial gate/drain overlap. Plots showing the trade-off between, and the process-dependencies of, the field reduction factor (FRF) and the series resistance are presented for the three cases. Structures with gate/drain overlap are found to provide greater field reduction than those without the overlap for the same series resistance introduced. This should be considered when comparing the double-diffused and spacer LDD structures. It is shown that gate/drain offset can cause the rise of channel field and substrate current at large gate voltages. Good agreement with simulations is obtained.

Chenming Hu

Papers

Plasma immersion ion implantation for SOI synthesis: SIMOX and ion-cut

A New 8T Hybrid Nonvolatile SRAM with Ferroelectric FET

Efficient gate oxide defect screen for VLSI reliability

Electromigration and Diffusion in Pure Cu And Cu(Sn) Alloys

A theoretical study of gate/Drain offset in LDD MOSFET's